AIR COMPRESSOR SALES AND SERVICE: PART DESCRIPTIONS FOR AIR COMPRESSOR PARTS

Friday, September 15, 2017

PART DESCRIPTIONS FOR AIR COMPRESSORS

Air Compressor Parts

Valve Assemblies
Valve Discs, Plates, Springs and Channels
Connecting Rods and Rod bearings
Cylinders, Cylinder Liners and Pistons
Overhaul Kits, TuneUp Kits, Head Kits
Gasket Kits and Individual Gaskets
Piston Ring Kits, Individual Piston Rings and Rod Packing
Oil Seals and O-Rings
Air Intake Filters and Housings
Compressor Oils, Lubricants
Safety Valves and Check Valves
Automatic Drain Valves
Other accessories for Air Compressors

The Throttle Control is mainly used on Gas Engine Driven Compressors to Reduce Engine Speed to Idle. When the Continuous Run Control (LGM or Pilot Valve) has Reached It Cut Out Setting. Saves Fuel and Reduces Engine and Compressor Wear.

The 1/8 NPT Inlet is Connected to the Throttle Control Port of the Vent Unloader or Connected to a Tee Off the Head Unloader Line for Pilot Valve Installations.

The Cable is Attached to the Appropriate Throttle Linkage on the Engine and the Cable Housing Should be Anchored Using the Supplied Cable Clamps.

During Operation the Vent Unloader or Pilot Valve Sends a Pressure Signal to the throttle control at the Cut Out Setting. Causing the Piston to Extend the Control Cable Which Pushes the Throttle Lever, Causing the Engine to Idle Down.